CNC pipe threading lathe operation and maintenance procedures

The operator must be familiar with the general performance, structure and rotation system of CNC pipe thread lathe, and it is strictly forbidden to use the equipment with super performance.

1. Before the Automatic CNC Pipe Threading Machine works:

Check whether the operating handle, switch, and knob of the cnc lathe pipe thread lathe machine are in the correct position, whether the operation is flexible, and whether the limit and safety devices are complete and reliable.

Turn on the power of CNC Oil Lathe, run the empty car at low speed, if there is any abnormal response, stop the machine to check or report to the repair personnel.

Check whether the height of the liquid level indication in the oil mark of the CNC turning machine is appropriate, whether the oil circuit is smooth, and add enough lubricating oil to the specified parts.

Run the car at low speed for 3-5 minutes and make sure that the lubrication, electrical system and various parts are running normally before starting to work.

2.High quality cnc lathe automatic is working:

It is strictly forbidden to use CNC pipe oil lathe with super performance. It is forbidden to place items on the guide rail surface and beam surface of CNC pipe threading lathe. It is strictly forbidden to beat, straighten and trim the workpiece on the work surface of CNC pipe threading lathe.

The cnc lathe pipe thread lathe machine clamps the workpiece and the tool must be firm and reliable, and the tool holder rotation device and the clamping mechanism must be used correctly.

Reasonably select the speed and cutting amount, and the operator is strictly prohibited from leaving the work position when the machine tool is running.

If there is any abnormal phenomenon during operation, it should be stopped immediately, the cause should be found out, and it should be dealt with in time.

3. After CNC Oil Lathe work:

All joysticks, switches and knobs must be placed in the stop position, and the power supply must be cut off.

Carry out daily maintenance of CNC turning machine.

Fill in the fixed equipment operation record shift record.

4.High quality cnc lathe automatic maintenance procedure

According to the inspection parts and the lubrication chart, the lubrication adjustment work is carried out to ensure the lubrication times in the shift.

Check the oil mark page and the oil supply of the oil pump.

Do a good job of cleaning the oil holes and lubricating parts of the automatic CNC pipe threading machine and cover it with a dust cover.

During the operation, according to the replacement of different processing materials, do a good job in chip removal, oil injection and lubrication.

5. Before get off work

Clean the CNC oil pipe lathe bed surface, spindle box, tool box and various parts of dust, iron filings, and apply anti-rust oil.